Execution:
Bearing surfaces honed,
outside diameter precision ground.

Slip-Fit Bonding:
The position of the bearing is given by push fit holes tolerance H5. The adhesive (order no. 281.648) provides optimum push retention whilst offering the following advantages:
- high accuracy and stiffness
- no problems to find position when changing bushings

We do not recommend to press fit for the same reasons mentioned above.

Note:
↗ Notes on ball bearing type guides at the beginning of chapter D.
*↗ Preloading see pairing classification at the beginning of chapter D
↗ Matching guide combinations, see selection matrix at the beginning of chapter D.
↗ Assembly guide lines / Dimensional requirements and tolerances at the end of chapter D.
Ø 8 - Ø 12 not available in tolerance range red = .30.

Tolerance range:
yellow = .10
green = .20
red = .30